ROCKVANTA Machinery
VIBRATING SCREEN SELECTION CHECKLIST

Use this as a starting brief. Mark unknowns rather than guessing. This is not a machine design, capacity guarantee or operating instruction.

MATERIAL AND FEED
- Material and source; sample identification and sampling date:
- Feed size distribution; largest expected lump; near-size fraction:
- Bulk density and measurement basis:
- Moisture range, clay/sticky fines, particle shape and seasonal variation:
- Normal and peak feed rate, units, wet/dry basis and measured/estimated status:
- Mass unit written in full: metric tonnes or US short tons (or specify another unit):
- Feeding method, batch size if relevant, loading height and distribution:

REQUIRED SEPARATION
- Desired size range and acceptable misplaced material for each outlet:
- Required usable-product output rate and units:
- Proposed aperture if known; required number of fractions/decks:
- Dry screening or wet duty; water addition and drainage if applicable:
- Existing blockage or wear issues, photographs and operating conditions:

SITE AND INTERFACES
- General arrangement, footprint and access:
- Feed height, discharge positions and downstream equipment:
- Supports/foundation; proposed static and dynamic loads for engineering review:
- Media replacement and drive-removal clearance:
- Voltage, frequency, phase, controls and site service restrictions:
- Dust, weather, corrosion, noise, operating hours and transport limits:

SUPPLY SCOPE
- Machine only, integrated plant or replacement media:
- Exact reference model, drawing revision or existing machine identification:
- Required deviations from the reference:
- Included hopper, drive, frame, chutes, conveyors and controls:
- Installation, guarding and isolation responsibilities:

QUOTATION AND ACCEPTANCE
- Equipment included and excluded; assumptions and unresolved questions:
- Capacity figure basis: feed versus accepted product, mass versus volume:
- Representative feed sample, agreed test conditions and sampling method:
- Required product grading and agreed acceptance criteria:
- Drawings, checks, identification and documents to accompany the order:
- Destination and requested delivery date:

A no-load running check does not establish production throughput or product grading. Operating changes require equipment-specific engineering review. Stop and isolate equipment before close inspection or measurement.

Guide: https://rockvanta.com/resources/vibrating-screen-selection-guide/
Equipment: https://rockvanta.com/equipment/screening-machines/
Enquiry: https://rockvanta.com/request-a-quote/#rfq-form